Birdman
Senior Member
Last Activity: Today, 06:28 AM
Joined: 22-11-2009
Location: Chessington, Surrey
-
Yeah it all got automatically sorted.. Could tell the person was dishonest though. Not even a reason or message. Anyway, you just move on.... -
Nice work.. They look great.Leave a comment:
-
Picked up a body kit with some pretty wild arches, but they are still not wide enough to cover my wheel. Bargain price and never used.. I think I will...Last edited by Birdman; 26-05-2023, 06:22 AM.Leave a comment:
-
Got a jimstim from the USA, so I can test my Megasquirt 2 ecu, just need a couple of leads and I should be able to simulate all the sensors and hook it...Leave a comment:
-
Well I guess I will find out later down the line when I take the sump off etc.. It just seems that the alloy components that take water are very clean....Leave a comment:
-
Are things normally that clean on an old engine?Leave a comment:
-
Well I swapped out the thermostat for the 82 degree one. Don't think I 've seen an engine before with such clean water ways! Looks like head may have...Leave a comment:
-
Got an 82 degree cool running thermostat and hope to fit that one evening this week. Looking at some longer duration camshafts, probably shouldn't , but...Leave a comment:
-
Trying out some blue alloy bling. May try and do on both sides of manifold.. took t piece from may twin boost gauges as I will want them to read the...Leave a comment:
-
Made up a quick bracket from alloy for 3 bar map sensor. Thought it might be good position and quick to see if the vacuum piping was all OK, but there...Leave a comment:
-
Got to extend the rear screamer pipe out to be just under main exhaust tip...Leave a comment:
-
Cut out Number plate area on fiberglass boot lid. Lets air out the back of the engine bay.. Will make a cowling over this some time.. Gives some access...Leave a comment:
-
A few things eventually arrived in post today, so hope to get some things done on the project over weekend..Leave a comment:
-
So I got the heat gun out and by heating the plastic dipstick and oil filler tube, I melted it and then sprayed it with pipe freezer spray. Got it moved...Leave a comment:
-
So I took the new engine loom and tried working out what plug goes where.. Most things marry up, but about 6 plugs that could be for the injectors. The...Leave a comment:
No activity results to display
Leave a comment: