An update to the progress of the gearbox building.
It's taken off like hot cakes. Started building a few custom gearboxes for people on...
AGoaty
Senior Member
"Ran my Rover K series VVC Mini. Phoenix for 8 years. On with project Scorpion. Lets hope its as much fun!
PG1 gearboxes built or repaired."
Last Activity: Today, 09:02 AM
Joined: 19-10-2008
Location: Keighley, West Yorkshire
-
You will need a slight cut just under the clutch slave cylinder to get the top of the engine more upright. If you take a line from the bottom of the cylinder...Leave a comment:
-
You say more noticeable from 3k up so does it idle properly?
If not then more likely a coil pack. I know my son had a few on his that were...Leave a comment:
-
You only swap the subframe gearbox arm from an MGF to the Metro to covert from R65 to PG1. Obviously then mounts, etc need to suit....Leave a comment:
-
My only concern is most metro conversions use the R65 gearbox. Look out for one that's converted to PG1. It's basically all MG F stuff and not difficult....Leave a comment:
-
Actually seen people use driveshafts without the circlip. Usually they don't machine the groove into the shaft as that's the point it snaps when under...Leave a comment:
-
Don't give up! 😎
Assuming you're running the PG1 gearbox, I can sort out whatever ratio choice you want with a reconditioned box and the...Leave a comment:
-
Looking good my friend. At least yours is moving forward! Stripes and badges are usually the last finishing touches so it must be close...
...Leave a comment:
-
Just reminiscing about this car as keeps coming up in conversation. I do miss not having a working Mini. 🙄
Only just noticed I didn't...Leave a comment:
No activity results to display
Leave a comment: