question about coilovers spring

ochumi · 09-10-2018, 10:00 AM

Hi i´m building a honda d16a9 engine, i put the protech coilovers with this spring

D Faulkner Springs LLP

REAR

1.9 Inch ID 9 Inch Free Rate: 150lb

FRONT

1.9 Inch ID 8 Inch Free Rate: 425lb

I see the car a bit high and the shock absorber nut is as loose as possible, and I do not know whether to change the rear springs to 8 "and the front ones to 7" in length, or that it has to stay that high. ..

also for the fronts in 7 "there is only up to 400lbs I would have to go to 2.5" for a load of 425lbs ...

I do not know how you see it

thanks

fynnbar · 09-10-2018, 06:05 PM

Rally Design do heavier 7" springs (but they're yellow ...)

09-10-2018, 10:00 AM	#1
ochumi Member Join Date: Apr 2017 Posts: 52	question about coilovers spring Hi i´m building a honda d16a9 engine, i put the protech coilovers with this spring D Faulkner Springs LLP REAR 1.9 Inch ID 9 Inch Free Rate: 150lb FRONT 1.9 Inch ID 8 Inch Free Rate: 425lb I see the car a bit high and the shock absorber nut is as loose as possible, and I do not know whether to change the rear springs to 8 "and the front ones to 7" in length, or that it has to stay that high. .. also for the fronts in 7 "there is only up to 400lbs I would have to go to 2.5" for a load of 425lbs ... I do not know how you see it thanks

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

09-10-2018, 06:05 PM	#2
fynnbar Senior Member Join Date: Mar 2009 Location: Dorset Posts: 1,304 Subframe: SAE CC: 1595 Make: Honda ECU: Standard obd1-P30	Rally Design do heavier 7" springs (but they're yellow ...)