return line to gas tank

porsh911t · 17-01-2010, 12:47 PM

hi guys, what are you doing to your gas tank for a fuel return line
any pics would be greatly appreciated thanx chuck

speedy · 17-01-2010, 06:28 PM

did you search allready?
and browse the different builds? if you did,you would see that some guys use spi/mpi tank from a mini... or made a swirlpot. the first have a return.
the swirlpot you can make with and without. if you make it without,you can make one in the tank...

Domcr250 · 06-02-2010, 08:47 AM

I just used the old mini feed line as a return into the top of the tank. The new feed is in 10mm cooper heating pipe and runs directly next to the old mini one, you can even use the same clips underneath the floor.

johnburnt · 11-02-2010, 04:51 PM

ive drilled a hole in the top of the tank where the two halfs meet and then using the petrol cap hole ive fitted a bulkhead fitting which a rubber pipe connects for now

17-01-2010, 12:47 PM	#1
porsh911t Junior Member Join Date: Dec 2009 Location: Bensalem,Pa Posts: 5 Subframe: Other CC: 1000 Make: Suzuki ECU: standard	return line to gas tank hi guys, what are you doing to your gas tank for a fuel return line any pics would be greatly appreciated thanx chuck

17-01-2010, 06:28 PM	#2
speedy Senior Member Join Date: May 2006 Location: marknesse netherlands Posts: 449 Subframe: Home Made Make: Suzuki ECU: standard,for now	did you search allready? and browse the different builds? if you did,you would see that some guys use spi/mpi tank from a mini... or made a swirlpot. the first have a return. the swirlpot you can make with and without. if you make it without,you can make one in the tank... __________________ SUUUZUUUUUKIIIIIIII

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

06-02-2010, 08:47 AM	#3
Domcr250 Member Join Date: Feb 2008 Location: Reading, Berkshire Posts: 45 Subframe: Home Made CC: 1300 Make: Suzuki ECU: Standard	I just used the old mini feed line as a return into the top of the tank. The new feed is in 10mm cooper heating pipe and runs directly next to the old mini one, you can even use the same clips underneath the floor.

11-02-2010, 04:51 PM	#4
johnburnt Member Join Date: Dec 2008 Location: north east Posts: 65 Subframe: MTB CC: 1800 Make: Honda ECU: standard p73	ive drilled a hole in the top of the tank where the two halfs meet and then using the petrol cap hole ive fitted a bulkhead fitting which a rubber pipe connects for now