Allen Mcd Help!

[steamfitter274]

Hi Allen,On your build site you show a short Yamaha oil filter.Can you give me the part number?Also I am at the point of making up my rear Engine/Trans mount.I am trying to install it towards the diff. side as it was in the stock Swift.I see you put yours more to the engine side.How has it worked out for you.
Thanks for your help,Jack

[Allan McD]

My engine mounts have done a couple of hundred miles and have been ok little movement I am using the rubbers supplied by Allspeed - http://www.16vminishop.co.uk/
The part no is 5DM-13440-00 its a yamaha motorcycle filter price in UK £10.50 inc VAT
Allan

[steamfitter274]

Thanks Allen, It looks like that filter will work as my front cross bar makes it hard to get the filter out with the engine in the car.The reason it asked about the rear mount is that it seems like the rear mount should be closer to the diff. side to even the stress on the two front mounts.If yours seems to work I'll try the same thing as it will be easier to make the mount fit in that area.
Thanks Again,Jack

[Allan McD]

After reading thgis again I notice that its the rear mount you are asking about that mount on my subframe was there when I purchased it I only made up the left hand front.
The oil filter being a fair bit smaller I would advize changing more often but most of us I am sure change oil and filter loads anyway.
Allan