Buying new HT leads

[JoeT]

Hi all,

If I want to buy some new performance leads, do I just need to get the standard ones for the B16A? I'm pretty sure it's all standard Honda on the kits, but I just want to check there's nothing weird about them....

Oh, and the same question to the 4-1 exhaust manifold, as I want a shiny one :)

Cheers!

Joe

[JoeT]

Lovely,

Thanks for the advice mate

[B20GT]

As a side issue 4-2-1 is meant to be better for mid-range and 4-1 is for very HIGH range. Most honda forum say 4-2-1 for road car. Unless you got plenty of bottom/middle and poor top :wink:

[TonyWells]

Hi Joe

my honda leads used to pop off every now and again. so when i got some new ones i had some make with ford zetec coilpack ends and honda plug ends.

i have since been told that if you grind the lip on the coilpack down with a dremel or something then the honda ones fit much better, but ive not tried it.

i was looking into getting a 4-1 manifold but was unsure if it would fit between the engine and the subframe so i went for a 4-2-1

tony