PDA

View Full Version : Rover PCD's

MattG
12-03-2004, 01:38 PM
are the 25's,45's the same PCD as the old K-series metro's ?
also what is the PCD again on the metro setup ?

cheers

Matt
12-03-2004, 02:11 PM
the 25 and 45 are 100mm pcd I think, same as the older 200/400 series and the same as some hondas (crxs etc)

can't remember the metro/100 pcd tho sorry

Gaz
Geehawk
12-03-2004, 02:15 PM
Rover metro/100 is 95.25 same as MGF, montego and some other obscure stuff.
Oz
12-03-2004, 03:41 PM
Does anyone know whether it would be possible to conver to 4x100mm PCD ?
Geehawk
12-03-2004, 03:52 PM
Yes. Minimivic and MarkLD have both done this. you may also have to have the central lug machined to fit a wheels centre bore too.
12-03-2004, 04:25 PM
Renault 5GTT alloys have a 100mm pcd and are also very inset, I've fitted them to a Mini (don't ask!!!!) and had to use 1" spacers to get them out to Wood & Picket arches!

They have a very similar offset to A series Metros.

Gaz
MattG
12-03-2004, 06:21 PM
hmmm intresting guys ... thanks

Matt
G67atp
12-03-2004, 07:18 PM
So does this mean that mgf wheels will fit on the metro hubs then ?


Dave :)
Geehawk
13-03-2004, 07:48 AM
MGF wheels will fit the hubs, but as Darren says the offset will place them well outside sportspack arches. Also the smallest MGF wheels are 15" so the rears will be a problem.
04-05-2004, 08:32 AM
MGF wheels will fit the hubs, but as Darren says the offset will place them well outside sportspack arches. Also the smallest MGF wheels are 15" so the rears will be a problem. i was discussing this with a mate a while ago and i found that if you were to fit moke (13 inch) radius arms clearence wont be as much of a problem :)