PaulAmes
28-02-2004, 02:57 PM
Hi all,
I have the smiths 10000 tacho which I installed last night - it seemd to work well apart for overreading which I was going to adjust later. However thismorning it doesnt - I mean it does nothing. Power is fine and the wires from the ecu havent changed since last night - not sure what they were reading last night - put a multimeter on it thismorning and it reads out as .3 volts. I also tried putting a 12v signal straight to the input line (I was at a loose end) and the needle did nothing. What is wrong - is the gauge faulty?
Paul
I have the smiths 10000 tacho which I installed last night - it seemd to work well apart for overreading which I was going to adjust later. However thismorning it doesnt - I mean it does nothing. Power is fine and the wires from the ecu havent changed since last night - not sure what they were reading last night - put a multimeter on it thismorning and it reads out as .3 volts. I also tried putting a 12v signal straight to the input line (I was at a loose end) and the needle did nothing. What is wrong - is the gauge faulty?
Paul